In the modern warehousing and logistics industry, electric forklifts have become an indispensable and important tool. However, driving an electric forklift is not a simple task. To ensure the safety and efficiency of the operation, the driver must master the driving skills and always pay attention to some key details.

First of all, the driver should check each control and alarm device before driving. Once any damage or defect is found, it should be repaired immediately to ensure the normal operation and safety performance of the forklift. This step may seem simple, but it is crucial to avoid safety incidents caused by equipment failure.

Secondly, not exceeding the specified load during handling is an important part of ensuring the safety of forklift operation. When the driver is handling the goods, he should ensure that the fork is all inserted under the goods and the goods are evenly placed on the fork. It is strictly forbidden to use a single fork tip to pick up goods, so as not to cause goods to drop or forklift to overturn due to uneven force.

In addition, smoothly starting, steering, driving, braking and stopping are also important skills for forklift driving. When driving on wet or smooth roads, drivers should pay special attention to slow down and steer to avoid loss of control and accidents caused by slippery roads.

When driving with loaded goods, the driver should lower the goods and tilt the gantry back to reduce the center of gravity and improve stability. When driving on ramps, you need to be more careful. When driving on ramps greater than one tenth, go forward uphill, go backward downhill, and avoid turning on the ramp. At the same time, in the process of forklift driving, it is strictly prohibited to carry out loading and unloading operations to ensure driving safety.

In addition to the above points, drivers also need to pay attention to the prohibition of people standing on the fork or carrying people in the car; No one is allowed to stand or walk under the fork; It is strictly forbidden to operate the vehicle and its accessories from a position other than the driver's seat; When leaving the car, the fork should be dropped to the ground, and put the gear handle in neutral position, the engine is turned off and disconnected from the power supply, and the hand brake should be pulled. When parking on the ramp, it is also necessary to pad the wheel with a pad to prevent the vehicle from sliding.